Polyglutamic Acid in Skincare: A Hydrating Humectant Explained
Polyglutamic acid is a large, water-loving molecule made by fermenting bacteria, and it is sold as a hydrating alternative to hyaluronic acid. It does hold water well on the skin surface, but the head-to-head evidence is still thin.
Key takeaways
- What it is: a long chain of glutamic acid units, made by fermentation and listed as sodium polyglutamate.
- What it does: holds water on the surface and leaves a light, slightly slippery film.
- The evidence: a 2024 review in Cosmetics describes better water retention than hyaluronic acid in one comparison.
- The catch: that comparison is brief, and the review gives few method details.
- Who it suits: people who like hydrating serums and want something a bit different to hyaluronic acid.
- Our position: we don't currently use it.
What is polyglutamic acid?
Polyglutamic acid, often written PGA, is a polymer built from many glutamic acid units. It is traditionally known from natto, the fermented soybean dish.
Cosmetic grades are made by fermenting bacteria in a tank, then purifying the result.
The finished ingredient is a white powder or a clear liquid that dissolves easily in water, which is why it slots into light serums and essences.
What does polyglutamic acid do for skin?
It is a humectant, which means it draws water in and holds it. A 2024 review in Cosmetics (Serra and colleagues) gives its molecular weight range as 50,000 to 2 million daltons.
The review notes that heavier versions tend to form a more occlusive film on the surface, reducing water loss. Lighter versions may reach a little deeper.
What does the research say?
The same review relays a comparison in which a PGA formulation held 45% water at 120 minutes, against 40% for propylene glycol and 36% for hyaluronic acid. It also reports no irritation from the formulations tested.
The review itself is not new research, and the comparison is described briefly. Read it as encouraging and early.
How does it compare with other hydrators?
| Ingredient | Type | Feel |
|---|---|---|
| Polyglutamic acid | Fermented polymer | Light, slightly slippery |
| Sodium hyaluronate | Salt of hyaluronic acid | Light, can feel tacky |
| Tremella | Mushroom polysaccharide | Cushiony, soft |
| Beta glucan | Oat or yeast polysaccharide | Soothing, light |
How do you spot it on a label?
The usual name is "sodium polyglutamate", sometimes "polyglutamic acid". Two typical lines:
- Water (Aqua), Glycerin, Sodium Polyglutamate, Sodium Hyaluronate: a hydrating serum using both polymers.
- ...Phenoxyethanol, Sodium Polyglutamate: near the end, likely a small supporting dose.
Who should skip it or go slow?
Humectants work best when they have something to bind to, so layer a moisturiser over the top. Without that, very dry or cold-weather skin may feel tight.
If your skin reacts to fermented ingredients or soy, check the product page. The skin quiz can help you narrow down what suits you.
How do you use polyglutamic acid?
Apply to damp, clean skin and follow with moisturiser. Follow the product's directions for how often.
Patch test first. Our patch testing guide shows how.
Do we use polyglutamic acid at Dope Skin Co?
We don't currently use it, and it is not in any of our formulas.
FAQ
Is polyglutamic acid better than hyaluronic acid?
One comparison suggests better water retention, but the evidence is early. Many routines use both.
Is polyglutamic acid vegan?
It is made by bacterial fermentation, but check the individual brand.
Is polyglutamic acid the same as sodium polyglutamate?
Sodium polyglutamate is the salt form, the more common label name.
Can I use it every day?
Usually, yes, if your skin tolerates it.


